Difference between revisions of "Mach4 Tips"
Jump to navigation
Jump to search
| Line 34: | Line 34: | ||
:[https://www.lua.org/start.html '''Lua Getting started'''] — programming language used for scripting Mach4 | :[https://www.lua.org/start.html '''Lua Getting started'''] — programming language used for scripting Mach4 | ||
| − | == | + | ==Additional Help== |
'''Links to related PPM Wiki pages:''' | '''Links to related PPM Wiki pages:''' | ||
Revision as of 15:21, 8 December 2024
Mach4 is the software we use to send G-code to our CNC router table at Pikes Peak Makerspace (PPM).
(We use Mach3 for our shopmaster bridge mill CNC.)
Contact Us if you cannot find your answer here on our Wiki or if you notice any information that is outdated.
Tips
Links to external sites:
Mach3 vs Mach4 for CNC Control- Compared [2022]
Artsoft / Mach Support Forums
G-code — Wikipedia entry
Classes
PPM announces its Upcoming events, including classes, on Meetup
Training
Links to external sites:
Mach4 Users Guide
Mach4 Product Home Page
Hand-Curated Links
Links to member-recommended external sites:
- Mach Support — on YouTube
- Lua Getting started — programming language used for scripting Mach4
Additional Help
Links to related PPM Wiki pages:
- Use the PPM Slack channel #CNC
- List of all PPM Slack channels
- Note that we have a Slack channel (#job-board) for members to post, discuss, or accept job opportunities either within PPM or from the community.
Search the PPM Wiki — include Content pages as well as Multimedia.
Contact Us if you cannot find your answer here on our Wiki or if you notice any information that is outdated.