3D Scanning
Pikes Peak Makerspace (PPM) provides the 3D scanning equipment and supplies listed below to its members.
The 3D Scanning equipment at Pikes Peak Makerspace (PPM) is for all our members to use without any additional required training (Level 1).
Links to related PPM Wiki pages:
Contact Us if you cannot find your answer here on our Wiki or if you notice any outdated information.
Training
- To help out with 3D Scanning at PPM, post a message to our #3d-printing channel on Slack.
- Use 3D Scanning and 3D Printing for Reverse Engineering — formlabs.com
Equipment Lists
| Item | Manufacturer | Model Number |
Resources |
| Structure Sensor
and charger |
Occipital | ST01 | website |
| Structure Sensor
bracket (Ice Blue) |
Occipital | SA03 | |
| 3D scanner | XBOX | ||
Hand Tools
- ☐ 3D Scanning Area hand tools should be marked with orange tape or paint.
- ☐ Return all tools to their proper location after use. This rule applies to all areas of our Makerspace.
Wish List
- Standalone 3D Scanner for Small to Large Objects
- Replacement for our broken 2012 iPad 4th Generation
Hand-Curated Links
Links to member-recommended external sites:
- CR-Scan Raptor — Blue Laser Consumer 3D Scanner
- 3D scan with a phone — sculpteo.com
- Multiple Raspberry PI 3D Scanner — instructables.com
Additional Help
Links to related PPM Wiki pages:
Use the PPM Slack channel #3d-printing
Note that we have a Slack channel (#job-board) for members to post, discuss, or accept job opportunities either within PPM or from the community.
Search the PPM Wiki — include Content pages as well as Multimedia.
Contact Us if you cannot find your answer here on our Wiki or if you notice any outdated information.