Introduction to the Zing Laser

To avoid the risk of fire, never leave the laser running unattended.
Never run the Zing without the ventilation fans running. The interaction of the laser and the material generates fumes.
The laser wavelength is such that the glass cover protects the eyes of the user. Do not attempt to run the laser with the cover open.

NEVER attempt to laser PVC or Vinyl

PVC - Poly Vinyl Chloride.
- The laser will split the molecule and release Chlorine gas which will irritate your eyes, your lungs, the eyes and lungs of anyone else around. It will also attack the finish on the laser optics DO NOT LASER PVC

The Zing uses a 30W CO2 laser to interact with materials by heating them. The actual effect is dependent on the material, the laser power setting, the laser speed setting, and the laser resolution setting.
The beam path originates from a laser generator on the bottom left of the machine and through mirrors, directed to the cutting head
The mechanics of the machine provide the XYZ translation.
To pass commands/jobs to the Zing you need to install the appropriate driver software onto the host computer.
To the computer, Zing looks like a weird printer.
The Zing interprets colors and lines into the appropriate laser marking/cutting sequence

Raster Images are made of pixels. Common examples would be photos or images found online
The cutter software will take your raster image and convert it into greyscale with each pixel being represented by a dot
The laser will pulse on and off as it follows these series of dots to create the image
The cutter achieves fine resolution by adjusting the power of the laser dependent on the darkness/lightness of the dot

Vector images are made of points and lines that connect points.
Can be fully represented by mathematical formulas.
The laser will use your vector drawing as a path to follow with the laser being continually on
This method of use is great for cutting out shapes from thin material.

To stop the Zing press STOP
To reset the Zing press RESET (laser turns off, head drives back to starting point)
To start processing a job, press GO
To toggle pointer on/off press the pointer button (7)
To manually set origin:
- Press X/Y Off (8) (this will disconnect the mechanical linkage between the gantry and the stepper motors allowing you to manually move the gantry)
- Open cover and move head to the desired position (BEWARE the optics)
- Press GO
- Press RESET

Contents